WIZnet W5100 Network Module with Mag Jack - WIZ811MJ

SKU : WIZ811MJ

WIZnet's WIZ811MJ works as a breakout board for their W5100 embedded TCP/IP chip. Also included on the board is an RJ-45 MagJack connector (RJ45 with X’FMR). It can be used as a component and little effort is required to interface to the W5300. The WIZ811MJ is an ideal option for users who want a simple solution to adding TCP/IP capability to their project.

There is no on-board regulation, so you'll need to supply clean/regulated 3.3VDC and 1.8VDC power sources. All pins of the W5300 are broken out to two pairs of 10-pin, 0.1" pitch headers.For detailed information on implementation of Hardware TCP/IP, refer to the W5300 Datasheet.

Features:

   - Supports 10/100 Base TX

   - Supports half/full duplex operation

   - Supports auto-negotiation and auto cross-over detection

   - IEEE 802.3/802.3u Compliance

   - Operates 3.3V with 5V I/O signal tolerance

   - Supports network status indicator LEDs

   - Includes Hardware Internet protocols: TCP, IP Ver.4, UDP, ICMP, ARP, PPPoE, IGMP

   - Includes Hardware Ethernet protocols: DLC, MAC

   - Supports 4 independent connections simultaneously

   - Supports MCU bus Interface and SPI Interface

   - Supports Direct/Indirect mode bus access

   - Supports Socket API for easy application programming

   - Interfaces with two 2.54mm pitch 2 x 10 header pin

   - Temperature : 0 ~ 70℃ (Operation), -40 ~ 85℃ (Storage)

Dimensions: Board: 55.5x25x23.5 (W x H x D)